Modern hard disks tend to generate lots of heat, which causes the mechanical components within the drive to risk failure. It is very important to try to keep your hard drives in a stable and cool environment. Therefore, hard drive coolers are becoming more popular as users look to improve hard drive lifetime and prevent terrible hard drive failure.
Today Titan unveiled the RTNV HDD cooler, TTC-HD90, which significantly helps reduce HDD Temperature, Noise, and Vibration.   It is a unique fanless design with high performance aluminum heatsink, which is able to provide great performance with super silent cooling.  Moreover, there are two large pieces of high conductive thermal pads attached to the upper and lower heatsinks.  This especially ensures proper heat transfer between the entire hard disk and the aluminum heatsinks, and the high conductive thermal pads can actually provide the best effect of heat dissipation and vibration reduction.  The RTNV HDD cooler also includes surrounded sound insulation and absorption pads to help reduce noise remarkably.
Installing this RTNV HDD cooler is a very simple and easy process. Just place the hard disk into the heatsink, tighten few screws as the installation guide and it's done! The RTNV HDD cooler is very elegantly designed and looks sleek and stylish.

Of course, more important is the actual cooling performance. We tested with a single drive (Samsung SATA 80G 7200RPM model) under load and used thermal probes placed on the areas of the hard disk to get temperature readings. (See the below pictures)

We also used the software HD Tune 2.53 to test the cooling performance of the hard disk and keep the CPU utilization at a constant 100%.  The programs were run for 60 minutes, and test temperature readings were recorded after the temperatures became stable.

You can see from the above performance table that the RTNV HDD Cooler is performing very well. Amazingly, it has lowered the chip temperature by nearly 16 degrees Celsius from 56.49C to 40.84C...more than a 27% decrease! From the software HDD tune 2.53, the RTNV HDD cooler has also brought the hard disk temperature down by a sizeable margin: nearly 23%. This should translate to more reliability in the long run and an increased sense of security. The RTNV HDD Cooler not only looks good, but works well too!!

  • Fanless design with high performance aluminum heatsink
  • High conductive thermal pad to provide the best effect of heat dissipation and vibration reduction
  • Includes surrounded sound insulation and absorption pad
  • Stylish design, easy installation, suitable for 3.5” Hard Disk Drives

 Outline Dimension  146x155x42 mm
 Material  Aluminum
 High conductive thermal pad
( Upper side )
 130x85x2 mm
 High conductive thermal pad
( Lower side )
 130x85x5 mm
 Net Weight  765 g